Pro-link 47% OMU 350 B14032 Bedienungsanleitung PDF herunterladen

U35 MATERIAL SAFETY DATA SHEET N/A=Not Applicable

Prepared by: Regulatory Affairs Dept. (Prepared According to 29 CFR 1910.1200) Effective Date: 1/09 Revision: n/a

SECTION 1-PRODUCT IDENTIFICATION AND SUPPLIER INFORMATION

Manufacturer’s Name:

Misco Products Corporation

Manufacturer’s Address:

1048 Stinson Drive Reading, PA 19605

Manufacturer’s Phone #: (610) 926-4106

Product Name: Crystal Cote 350

Generic Name: Polyurethane Wood Finish

Chemical Family: Solvent Urethane Blend

Formula: Proprietary

Supplier’s Name:

Supplier’s Address:

Supplier’s Phone #:

SECTION 2-INGREDIENT INFORMATION

CHEMICAL NAME CAS NO. WT. % PEL TWA-TLV STEL-TLV

Mineral Spirits 64742-47-8 30 to 35 300 ppm 100 ppm N/A

Regular Mineral Spirits 64741-41-9 10 to 15

Oil Modified Urethane Resin N/A 50 to 55

Xylene 1330-20-7 1 to 5 100ppm 100ppm 150ppm

Ethylbenzene 100-41-4 0.1 to 1 100ppm 100ppm 125ppm

SECTION 3-PHYSICAL DATA SECTION 4-FIRE AND EXPLOSION HAZARD DATA

Boiling Point (°F): 282 F. Initial Specific Gravity: 0.91

Vapor Pressure: 6 mm Hg @ 68 F. Vapor Density (Air=1): 5.1

% Volatile: 45+ pH: N/A

Solubility in Water: Nil Evaporation Rate (Water=1): 0.6

Physical Description: Moderately viscous yellow liquid with characteristic solvent odor.

VOC Content (Subpart D §59.406) : < 350 grams/liter

Flash Point (Method Used): 100°F. (TCC)

Upper Explosion Limit: 6.0% Lower Explosion Limit: 1.0%

Extinguishing Media: Foam, CO

, dry chemical.

Special Firefighting Procedures: Do Not Use Water.

Unusual Fire and Explosion Hazards: Drums heated by fire can explode.

SECTION 5-REACTIVITY DATA

Stability: Stable Hazardous Polymerization: May occur through oxidation, leading to exothermic reaction. Heat generated by oxidation may lead to

spontaneous combustion of materials such as rags, paper towels, etc., used for clean-up

Hazards Decomposition Products: Carbon monoxide possible if burned. Incompatibility (Materials to Avoid): Strong oxidizers.

SECTION 6-STORAGE AND HANDLING INFORMATION

Combustible liquid. Avoid contact with heat, spark or open flame. Eye irritant. May cause skin irritation. Keep out of reach of children. For use by trained personnel only. Keep

unauthorized personnel away when applying to floor. Keep container closed during storage. For institutional and industrial use only. Avoid contact with eyes, skin and clothing.

Wear rubber gloves when handling. Wear protective boots when applying to floors. Avoid breathing of vapors. Use in well-ventilated area.

SECTION 7-HEALTH HAZARDS AND FIRST AID SECTION 8-SPECIAL PROTECTION INFORMATION

Effects of Overexposure:

Skin: Prolonged or repeated contact may cause irritation, defatting, or dermatitis.

Eyes: Eye irritant. May cause redness, swelling, or blurred vision.

Inhalation: May be irritating to the nose, throat, and lungs. Prolonged breathing can

cause headache, nausea, dizziness, weakness, and fatigue. Some reports have associated

repeated and prolonged occupational overexposure to solvents with permanent brain and

nervous system damage.

Ingestion: Can cause irritation of the gastrointestinal tract, nausea, vomiting, and

diarrhea. Aspiration of material into the lungs can cause pneumonitis.

Other: May cause liver damage and/or kidney damage.

Contains ethylbenzene, which has been determined by NTP to be an animal carcinogen

with no known relevance to humans. IARC has classified ethylbenzene as possibly

carcinogenic to humans (2b) on the basis of sufficient evidence of carcinogenicity in

laboratory animals but inadequate evidence of cancer in humans.

Respiratory Protection: NIOSH approved hydrocarbon cartridge or self-contained

apparatus when used in enclosed areas.

Ventilation Requirements: Provide local exhaust to keep TLV of Section 2 in-

gredients below acceptable limit. Open doors and windows when handling and during

drying period.

Protective Gloves: Solvent proof rubber recommended.

Eye Protection: Safety glasses recommended.

Other Protective Equipment: Eye wash station should be available nearby. Protective

clothing and footwear (rubber boots) when using on floors.

First Aid Procedures:

SECTION 9-SPILL OR LEAK PROCEDURES

Skin: Remove contaminated clothing. Wash with soap and water. Seek medical attention

if irritation persists.

Eyes: Flush with large quantities of water, holding eyelids open. Seek medical attention.

Inhalation: Get to fresh air. If breathing is difficult, give oxygen. Seek medical attention

if symptoms persist.

Ingestion: Do not induce vomiting. Seek medical attention immediately.

Steps to be taken in Case Material is Released or Spilled: Shut off all ignition

sources. Ventilate area well. Floors will become slippery. Avoid walking in product.

Keep unessential personnel away. Mop up or otherwise absorb and hold disposal.

Avoid discharge to sewer or open waterways.

Waste Disposal Method: Any method in accordance with local, state and federal laws.

Best method is to recycle or reuse for intended purpose. If discarded, this material and

containers should be treated as hazardous waste based on the characteristic of

ignitability as defined under federal RCRA regulations (40 CFR 261). Materials used

to absorb product should be soaked in water-filled containers or rinsed with water prior

to discarding in trash receptacles. Do not

dispose of into storm drain, stream, river or

to ground. Rinse container thoroughly before discarding in trash.

SECTION 10-REGULATORY INFORMATION

SARA Title III - Section 311/312 -Hazard Categories: Domestic Shipping Information:

HMIS Hazardous Materials

Yes - Fire Hazard FOR CONTAINERS > 1 Gallon : Floor Coating

Identification System

No - Sudden Release of Pressure Hazard

Health 2

No - Reactivity Hazard FOR 1 GALLON CONTAINERS : Not Available in this size

Flammability 2

Yes - Immediate (acute) Health Hazard

Reactivity 1

Yes - Delayed (chronic) Health Hazard FOR CONTAINERS < 1 GALLON : Not Available in this size

Personal Protection D

FOR EMERGENCY MEDICAL OR TRANSPORT INFORMATION: CHEM-TEL, Inc. @ 800-255-3924 (24 hours, 7 days per week)

This product contains the following toxic chemical(s) subject to the reporting requirements of section 313 of the Emergency Planning and Community Right-To-Know Act of 1986 and of 40 CFR 372.

CAS# Chemical Name Percent by Weight

1330-20-7 Xylene 1 - 5

100-41-4 Ethylbenzene 0.1 – 1.0

This product contains the following chemical(s) which have been established to be either a carcinogen or suspected carcinogen.

CAS# Chemical Name Percent by Weight

100-41-4 Ethylbenzene 0.1 – 1.0

SECTION 11-OTHER INFORMATION

This company cannot anticipate all conditions of handling and use of this product. Therefore, this company accepts no responsibility for results obtained by the application of this information, or the safety and

suitability of our products either alone or in combination with other products. It is the responsibility of the user to provide a safe workplace, using the health and safety information contained herein as a guide.

This company will accept no liability for damages or loss incurred from the improper handling and use of this product

Pro-Link, Inc.

Canton, MA 02021

1-800-74-LINKS

47% OMU 350 Finish

Inhaltsverzeichnis

Seite 1 - 47% OMU 350 Finish

U35 MATERIAL SAFETY DATA SHEET N/A=Not Applicable Prepared by: Regulatory Affairs Dept. (Prepared According to 29 CFR 1910.1

Kommentare zu diesen Handbüchern

Keine Kommentare

Pro-link 47% OMU 350 B14032 Bedienungsanleitung

Stöbern Sie online oder laden Sie Bedienungsanleitung nach Für Zuhause Pro-link 47% OMU 350 B14032 herunter. Pro-Link 47% OMU 350 B14032 User Manual Benutzerhandbuch

Inhaltsverzeichnis

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Für Zuhause Pro-link 47% OMU 350 B14032